The ceramic PTC thermistor will help to keep the constant temperature when it heats up to the set temperature.
There's a dial that moves between 100°C-220°C for different use, the speed of the glue flow is different according to the different temperature, and you may need use a small flat-bladed screwdriver spinning on the dial to change the temperature.
Interchangeable Copper Nozzle
The diameter of the nozzle is about 13mm, orifice diameter is 3mm,length of whole nozzle is about 23mm and you can change to the longer one for different use.The copper nozzle has the better thermostability than the other nozzles.
1 Diameter of the glue strips should between 10.8mm-11.8mm.If the the applied stick doesn't match,the glue gun may be damaged.
2 The nozzle and the glue liquid are hot when the gun is working, please don't touch it.
3 If the glue gun doesn't work for 15min, please cut off the power source to avoid the melting glue recirculating or damage.
4 It may has the light smoke the first use, it is normal and it will die off 10min later.
5 Please let the bracket stand to cool down the gun for several minutes after use, and don't change the other power cord with it.
6 If the strip is left after use, please don't pull it off,just let it in the gun for the next use.
7 It is normal for some glue flowing out after the few seconds you finish working because of the inertia pressure.
1* Hot Glue Gun
Anti-overheating with ceramic PTC thermistor,,automatic thermostat to save energy, also retrofit the thermal insulation on the tail to prolong the life of the gun.
3-5 min warm up time,indicator light on when heating and off when it heats up to the constant temperature.
Temperature adjustable between 100°C-220°C,trigger feed mechanism to controls flow of glue.
Non-drip tip which built in leak-proof valve,insulated and interchangeable nozzle, cooling hole to cool down the temp and a rubber coating for easier cleaning.
100Watts,110-240V,used with the glue strips diameter between 10.8mm-11.8mm,15-20g/min melting out.